| Author | Narudom Therdkiet |
| Call Number | AIT Thesis no. ISE-98-37 |
| Subject(s) | Prototypes, Engineering
|
| Note | A thesis submitted in partial fulfillment of the requirements for the degree of Master of Engineering, School of Advanced Technologies |
| Publisher | Asian Institute of Technology |
| Abstract | The purpose of this thesis study was to implement the rapid prototyping technology to
the product design and development process and analyze the impact of them.
This thesis study was concerning the air-conditioner remote controller design and
development supported by Intronic Co., Ltd. There are two proposed remote controller design,
the wall mounted remote controller and desktop remote controller, and one packaging design.
The design and development process was perform systematically from the conceptual design,
embodiment design, detailed design, rapid prototyping fabrication, assembly test, and design
analysis.
The 3D CAD system is used to produce mostly output from the virtual prototype, 3D
solid model, STL file, and 2D dimension drawing. The prototypes were fabricated by Fused
Deposition Modeling (FDM) Method at Kasetsart University.
The analysis was about to compare between the product design and development
process with and without the implementation of rapid prototyping technology, in term of time
and cost. |
| Year | 1998 |
| Type | Thesis |
| School | School of Advanced Technologies |
| Department | Other Field of Studies (No Department) |
| Academic Program/FoS | Industrial Systems Engineering (ISE) |
| Chairperson(s) | Naber, Helmut; |
| Examination Committee(s) | Bohez, Erik L.J.;Igel, Babara ; |
| Degree | Thesis (M.Eng.) - Asian Institute of Technology, 1998 |