AIT Thesis no.ST-21-07
Determination of dynamic horizontal stiffness parameters of a pile foundation using acceleration and dynamic strain measurements
by Sawumma, Sadriar Alam
|
AIT Thesis no.ST-21-08
Mix design and characteristics evaluation of high-performance concrete incorporating silica fume and fly ash using modified andreason & andersen particle packing model
by Karna, Binay
|
AIT Thesis no.ST-21-09
Using data analytics approach to estimate the efficiency of the structural design of tall buildings
by Sapkota, Binod
|
AIT Thesis no.ST-21-10
Quantitative assessment of dissipated energy from the structural component under seismic ground motions for mid rise building
by Poudel, Jhabindra
|
AIT Thesis no.ST-21-11
Development of rapid setting and self-compacting repair concrete
by Lu Min Thant
|
AIT Thesis no.ST-21-12
An experimental study on structural damage identification using measured acceleration data
by Regmi, Abhishek
|
AIT Thesis no.ST-21-13
A displacement-based design Procedure for low to mid-rise buildings with masonry infills in the Philippines
by Tuala, John Lorenz Sibugan
|
AIT Thesis no.ST-21-14
Seismic response of asymmetric rectangular blocks in high-rise buildings
by Sivapalan, Sivaram
|
AIT Thesis no.ST-21-15
The development of a framework for damage-index decoupling matrix determination from the actual structure
by Napat Kumya
|
AIT Thesis no.ST-21-16
An experimental study of the extruded mortar using 3D printing technique
by Hussain, Raisa Tamsin
|
AIT Thesis no.ST-21-17
Development of rapid setting and self levelling repair mortar
by Sultana, Jennifar
|
AIT Thesis no.ST-21-18
Suppression of wind-induced responses of structures by using plasma actuators
by Thanathip Klinfueang
|
AIT Thesis no.ST-21-19
In-plane behavior of reinforced masonry walls subjected to lateral forces : an experimental approach
by Thittiya Ruangsak
|
AIT Thesis no.ST-21-20
Quantitative assessment of dissipated energy from structural components under seismic ground motions for a low-rise RC framed building
by Neupane, Basanta
|
AIT Thesis no.ST-22-01
Suppression of wind-induced response of tall buildings by using a tuned mass damper made of multi-stage steel-laminated rubber bearings
by Chanon Chotmanee
|
AIT Thesis no.ST-22-02
Development of sprayed mortar for fabric formwork
by Sis Lwin Phone
|
AIT Thesis no.ST-22-03
The structural frame member health evaluation of a scaled frame structure by normalized modal strain approach
by Titiwas Jantagoonroj
|
AIT Thesis no.ST-22-04
Effect of performance-based wind design on seismic performance of a tall building in high wind and moderate seismic zone
by Ahmed, Wamiq
|
AIT Thesis no.ST-22-05
Evaluation of the soft-storey performance of 2d reinforced concrete frame using natural frequency
by Shrestha, Sneha
|
AIT Thesis no.ST-22-06
Estimation of seismic structural responses through accelerometer measurement : an experimental and numerical study
by Fathisepahvand, Mojtaba
|